Rotary Shoes, manufactured from specially heat-treated alloy, provide the ultimate in toughness and durability. This tool is used to cut a clearance between the fish and the wall of the wellbore. Each shoe is designed to fit a particular downhole need and is run on the bottom of the washover string. Shoe design is dictated by where it will cut: on the bottom, on the outside diameter or on the inside diameter. When hole size permits, additional clearances can be cut by using side ribs to enable greater circulation. [Note: Because the inner milling tooth diameter of rotary shoe is large, the reverse torque is large, so low pressure and slow rotation mode should be adopted in the use of rotary shoe. In general, the drilling pressure should not exceed 10 KN and the rotational speed should not exceed 50 r/min.]

Casing/Wellbore Dia.		Rotary shoe OD （mm）	Rotary shoe Length （mm）	Recommended Screw Thread	P.N. Rotary Shoe
4in	101.6mm	95	400	FJWP	TXX095
5-1/2in	139.7mm	114	500	FJWP	TXX114
5-3/8in	146.05mm	118	500	FJWP	TXX118
6-5/8in	168.28mm	136	425	FJWP	TXX135
7in	177.8mm	152	450	FJWP	TXX152
7-5/8in	193.68mm	160	450	FJWP	TXX160
8-5/8in	219.1mm	185	550	FJWP	TXX185
12-1/4in	311.15mm	203	450	FJWP	TXX203
15-5/8in	396.88mm	298	450	FJWP	TXX298
20in	508mm	406	450	FJWP	TXX406